- This topic has 3 replies, 3 voices, and was last updated 20 years, 3 months ago by
.
-
Posts
-
Am finishing up restoration of #3056. Both chain plates are bent. I don’t dare not change them out while the boat is apart. Anyone with experience in doing this job that cares to give any ideas to make the job easier or better?
alThe chainplates normally look bent inward. When you attach the stays the chainplates are usually in line with the stays.
I would call Flying Scot, if you have a question. I am sure Harry would be glad to offer answers. If you actually need new chainplates, it probably makes sense to buy them from Harry, as he sends directions and has installed thousands.
Phil Scheetz
FS 4086yeah, am pretty sure they’re bent. they cock about 20 degrees FORWARD and are crimped on the leading edge. they took a hit somewhere along the line.
any install ideas? i will get them from the factory to keep the boat class legal.
alg
- You must be logged in to reply to this topic.